Polishing questions?

  • Please add our email support@horologyboard.com and/or domain horologyboard.com into your whitelist to make sure emails are not filtered or blocked. If you have registered but have not received your activation email, please check you spam/junk folder. If you still cannot find your email to activate your account, please Contact Us. Thank you.


Content Contributor
Feb 24, 2018
Hey guys,
Over the weekend I modified my tropic rubber strap from Oris. Since it's being sported on a 16610 the logo on the buckle just wasn't going to work...

Dremel / scotch pad to the rescue - I was able to get the stamped logo out and the buckle looks pretty good... There are still some swirls from the Dremel work - I could spend hours with a scotch pad and get them out eventually, but hoping there was an easier solution?

Dremel with buffing wheel?

Tried to capture the buckle state in the attached pics. Thoughts?